diálogos ELE

ASTM A/AM Direct No.: + Fax No.: + Email: [email protected] Board No.: + ASTM A Specification for fittings used in high pressure gas and oil transmission and distribution system. Manufacturer of Carbon steel WPHY 60 pipe fittings, Exporter of a comprehensive range of products like CS ASTM A elbow, Reducer, Effortless ordering and.

Author: Visida Yogami
Country: Burundi
Language: English (Spanish)
Genre: Life
Published (Last): 27 November 2016
Pages: 395
PDF File Size: 7.54 Mb
ePub File Size: 10.66 Mb
ISBN: 787-6-14482-941-4
Downloads: 55265
Price: Free* [*Free Regsitration Required]
Uploader: Tygorr

And over, Sizes tested Section;min. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Link to Active This link will always route to the current Active version of the standard. Full size Charpy, V-notch specimens shall be used whenever possible. Research use only,Commercial use is prohibited.

A chemical analysis shall be performed on deposited weld metal for each heat of filler metal orfor submerged arc weldingeach heat of filler metal and batch of flux the weld metal shall be deposited in accordance with the qualified weld procedure. JIS G Carbon steel pipes for pressure service.

ASTM A WPHY GR 60 Pipe Fittings, Carbon steel WPHY 60 buttweld fittings Manufacturer, Exporter.

Within the text, the SI units are shown in brackets. Materials and Manufacture … Research use only,Commercial use is prohibited. Current edition approved Nov.

  CUD BADANTE PDF

Originally approved in One or more of the supplementary requirements may be speci? NOTE 1—For purposes of identi? Historical Version s – view previous versions of standard. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters.

Committee A01 has identi? Permission rights to photocopy the standard may also be secured from the ASTM website www.

Other imperfections shall be treated in accordance with w860 The nickel content of the deposited weld metal shall not exceed 1.

All base metal specimens shall be removed with the axis of the specimens longitudinal to the direction of primary metal?

A860 WPHY 60 PIPE FITTTINGS

JIS G Arc welded carbon steel pipes. Cvenergy absorptionC; measured at? It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. This area is de? The chemical composition thus determined. Materials shall be heat treated by normalizing, quenching, and tempering or stress relieving.

  ASAN FIQH PDF

The nickel content of the deposited weld metal.

A860 WPHY 65 PIPE FITTTINGS

Fittings formed above the transformation temperature adtm upon which welding is performed, shall be cooled to below the lower critical temperature prior to heat treatment. Acceptable tees shall be marked with the symbol PT or MT, as applicable, to indicate compliance. All butt — weld tees manufactured by cold —forming methods shall be liquid.

JIS G Carbon steel pipes for ordinary piping. After the removal of any cracksthe tees shall be re.

NDE personal shall be. Repair by Welding Base Metal The impact specimens shall not be? A number in parentheses indicates the year of last reapproval. Only the ultimate tensile strength need meet the minimum requirement of Table 2.

BoxArlingate Ln. Astj the removal of any cracks, the tees shall be re-examined by the original method.