diálogos ELE

OUTPUT Control,Alarm or Logic Output. Universal Process Input. 0 to 50 mV Z. 0 to 20 mA Z. 0 to 10 V Z. Pt CAT II. Y c. ESM MODULE – 2. NC. is done with it ‘s selectable ON-OFF, P, PI, PD, PID,. AutoTune and Self Tune PID properties. ESM, ESM ESM, ESM ESM eng esm 02 v04 07_14_ Home; eng esm 02 v04 07_14_ Anterior. eng esm 02 v04 07_14_

Author: Kajimuro Nak
Country: Armenia
Language: English (Spanish)
Genre: Art
Published (Last): 16 September 2004
Pages: 319
PDF File Size: 3.40 Mb
ePub File Size: 15.26 Mb
ISBN: 720-7-82459-803-8
Downloads: 15211
Price: Free* [*Free Regsitration Required]
Uploader: Nikojinn

It can be adjusted from to seconds. It determines operation form of hysteresis.

Unit selection Configuration of analogue input module in Module-1 socket. Process output value in manual control is not taken into consideration while passing from manual control to automatic control.

EMKO Esm Instruction Manual (Page 97 of )

If it is 0, integral control part does not perform. Press menu button to exit without saving Set value. Blinking can be canceled by pressing Enter button. Emko Elektronik Sanayi ve Ticaret A.

IMPLEMENTATIONS

Defines minimum value for selectable dual point calibration. It determines logic output function of Output This parameter is visible if one of the analogue input modules is plugged in Module-1 or Module-2 socket Measurement input selection for Output-3 alarm output.

  KXTS 580 PDF

Use a cloth dampened in ethyl alcohol or water to clean the external plastic case. Ezm Hysteresis value for OUT If it is 0, derivative control is deactivated. Maximum 10 Ohm Sensor Break Protection: The warranty period starts from the delivery date.

Emko Elektronik

This parameter is visible if point position and unit parameters are same for process input and analogue input module. After complated the tunning correctly, integral time value changes automatically. It can be adjusted from 1 to Please refer to Table-1 for selection of input type and scala. User defined process set dsm is considered Deviation high alarm.

Minimum value of calibration is and maximum value of calibration is It is active if process input of Module-1 is TC input. Configuration of analogue output module in odule-1 It is active if output function of Module-1 is heating or cooling.

Display adjustment low point value is fixed todisplay adjustment high point value is fixed to User defined process set value is not considered Current transfer ratio for Module Never attempt to disassemble, modify or repair this unit.

  INFINITE INSIGHTS INTO KENPO PDF

EDA-3700 Process Indicator

If heating and cooling PID control functions operate together, this parameter is wsm considered. Even as a result of the cooling PID calculation device calculates the output value less than this parameter, cooling output is active minimumor OLLC parameter. Warranty EMKO Elektronik warrants that the equipment delivered is free from defects in material and workmanship. This parameter is used for shifting the proportional band.

If you have any of these parameters is observed 2. Alarm latch canceling is not performed.

It is active if logic output function of Module-1 is an alarm output. If motorized valve control is selected this parameter is active ON The minimum duration of the valve motor drive output 0.

Sensor connection is wrong or there is no sensor connection.